The Model sc100 Controller receives data from one or two sensors. Its plug-and-play, mix-and-match operation lets it fit into any facility or workflow. Digital communication with any Hach digital sensor or probe is simple and reliable. sc100 is also available with RS485/MODBUS® Communications (LXV401.52.02002) or RS232/MODBUS® Communications (LXV401.52.01002). For other communication options which may be available, contact Hach Technical Support or your Hach representative.

• Simple, Reliable Data Collection
• "Plug and Play" Operation
• One controller for One or Two Sensors
• One controller for One or Two Parameters
• One controller for many Options

  Simple, Reliable Data Collection

  A built-in data logger collects measurement at user selectable intervals (1 to 15 minutes), together with calibration and verification points, alarm history, and instrument setup changes for up to 6 months. With a two-year warranty, the Hach sc100 Controller is built to last.

  "Plug and Play" Operation

  there's no complicated wiring or set up procedures with the sc100 controller. Just plug the sensor in and it is ready for use without special ordering or software configuration.

  One controller for One or Two Sensors

  The Hach sc100 Controller receives data from up to two sensors. Use any of Hach's line of digital sensors for pH/ORP, conductivity, dissolved oxygen, or turbidity.

  One controller for One or Two Parameters

  Not only can the sc100 controller be used for up to two sensors, but the sensors need not be the same. Mix and match any combination of parameters.

  One controller for many Options

  Communications using RS485/MODBUS® or Profibus DPV1® protocols are available. (Contact your Hach representative for other communication protocols.) Multiple control functions include built-in PID, control contacts, and alarm functions.

  What's in the box

  Controller, Mounting Hardware, Basic User Manual

  Specifications

  Enclosure Rating:NEMA 4X/IP65

  Length:5.7 in ( 144 mm )

  Warranty:2 years